Check all parts of the feed extruder, especially the connecting cargols and anchor cargols of each section of the extrusioning chamber, the connecting cargols entre el motor base and the frame, and the cargolat connection between the extrusioning chamber and the frame. There must be no looseness. Manually rotate the main shaft. At this time, there should be no scratching sound in the puffing chamber. Start the feeding auger and check its stepless high-speed performance to ensure normal operation.
Check and clean the water and gas paths before starting the feed extruder. All filters need to be cleaned. Before starting the machine, check whether the wiring of the electronic control part is correct, whether the steering of each motor is correct, and whether the control is reliable. After stopping the machine, you must wear anti-high temperature gloves, quickly remove the descàrrega motlle, and clean it immediatament while it is hot. I start the main motor to empty the material acumulat in in the expansion chamber. When corn is puffed, soja farina should be added to rinse the material in the cavity. Paga atenció a seguretat quan descàrrega la màquina, i do no allow anyone to stand directly in front of the machine to evitar perill caused by residual pressure in the extruder cavity. After the equipment is running normally, it must not be shut down at will.
